Resin Art

• Permanent, opaque pigment-based ink markers Suitable for many surfaces: including thick card, metal, glass, plastic and ceramic Bright and vivid paint-like colours Plastic barrel 3.0mm bullet point PVC, toluene and xylene free

• This craft resin & hardener is ideal for jewellery making, dome stickers, dome embellishments and to coat wooden furniture for sheen & protection.
• It is water resistant when dry and gives a glossy finish to your projects. Procedure - To make a resin embellishment, mix the craft resin with craft hardener in 1:1 ratio with the help of a wooden stick.
• Then pour the mixed solution in any mould of your choice.
• Let your project sit for about 30 minutes making sure there are no bubbles. Your resin embellishment is ready.

• Odour & fume free.
• Auto bubble release
• Self-levelling resin
• Non-yellowing
• Mixes well with Little Birdie Resin colour / pigments
• Long shelf life
• Water & stain resistant
• No pot life: 45 minutes
• Full internal cure: 48 hours
• Touch dry: 12 hours
• Cure to handle: 10 hours
• Overcoat time: after full curing

How to use art resin:

Mix Resin and Hardener in the ratio 2:1 by volume preferably in paper/silicone cup with a wooden stirrer.

Stir the mixture well for about 3 minutes. Let it sit for 1 minute for bubbles to release.

Place the base on a levelled surface & pour the resin over your work.

Bubbles if any, will start rising to the surface & will pop on their own. If not, use a hot air gun over the un-popped bubbles.

The Resin needs to sit in a dust-free space while it cures. Within 24 to 48 hours fully cured (Curing time depends on weather conditions)

If required, apply 2nd coat only after the resin is fully cured.

• Odour & fume free.
• Auto bubble release
• Self-levelling resin
• Non-yellowing
• Mixes well with Little Birdie Resin colour / pigments
• Long shelf life
• Water & stain resistant
• No pot life: 45 minutes
• Full internal cure: 48 hours
• Touch dry: 12 hours
• Cure to handle: 10 hours
• Overcoat time: after full curing

How to use art resin:

Mix Resin and Hardener in the ratio 2:1 by volume preferably in paper/silicone cup with a wooden stirrer.

Stir the mixture well for about 3 minutes. Let it sit for 1 minute for bubbles to release.

Place the base on a levelled surface & pour the resin over your work.

Bubbles if any, will start rising to the surface & will pop on their own. If not, use a hot air gun over the un-popped bubbles.

The Resin needs to sit in a dust-free space while it cures. Within 24 to 48 hours fully cured (Curing time depends on weather conditions)

If required, apply 2nd coat only after the resin is fully cured.